Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dot1x Problem

Hi,

We are seeing our wired devices on our Packetfence controlled network being prompted for credentials each time they are plugged in/turned on/rebooted, and often the credentials are being rejected.

Radius debug logs show that Access-Accept is being sent to the device, but the device is not ever getting onto the network.

Enabling debug on my Cisco 2960 test switch I can see the error below:

%DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address

The reason I don’t think that this is a packetfence/radius issue is that we’re not having any issues with wireless clients.

I hope someone can help.

Jamie.

2 REPLIES
Purple

Dot1x Problem

Hi,

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_46_se/system/message/msg_desc.html#wp532108

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
New Member

Dot1x Problem

Thanks for the reply.

I looked at the MAC address table but it isn't full. I think that error may be a "red herring" because I have debug running on another switch and a user just had the same problem but the "%DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address" didn't appear???

cadet alain wrote:

Hi,

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_46_se/system/message/msg_desc.html#wp532108

Regards

Alain

Don't forget to rate helpful posts.

122
Views
0
Helpful
2
Replies
CreatePlease login to create content