Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

double nat translation

hi all!

help to understand the following issues:

for packet, that entering the router (cisco 2811) must be changed source and destination address. for example on the interface fa0/0 hits packet with the source address 10.10.10.1 and the destination address 192.168.240.1, and at the exit from the router (fa0/1), I need to have a packet with the source address of 192.168.4.4 and destination addresses 192.168.4.1

192.168.4.1 - host, which could take the packages from its subnet (192.168.4.0/24)

10.10.10.1 - can apply only to hosts on the network 192.168.240.0/24

P.S. sorry for my english

5 REPLIES

Re: double nat translation

If the router has 2 x interfaces:-

fa0/0 connected to the subnet 10.10.10.0/24

and

fa 0/1 connexted to the subnet 192.168.240.0/24

AFAIK you cannot double NAT to an IP range, that is not directly connected to the device.

New Member

Re: double nat translation

I have attached a simplified scheme, I hope this helps ...

New Member

Re: double nat translation

Also, I have found here a similar topic (http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=LAN%2C%20Switching%20and%20Routing&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40^1%40%40.2cc2a432), but I have ip nat inside and ip nat outside vice versa. I can not change thish because on both interfaces, there are already some translations

Re: double nat translation

you diagram does not show where the 192.168.240.0/24 is?

New Member

Re: double nat translation

there is no it. our border router route packet on cisco 2811 to fa 0/0 (172.16.1.1). if needed, i may on interface fa 0/0 create a subinterface with 192.168.240.1 ip

397
Views
0
Helpful
5
Replies