both mark the value for IP precedence in the IP header where the value can be from 0 (routine) up to 7 (Network control) although you normally don't use 6 & 7 as these are used for routing updates etc.
The difference between the 2 is "set precedence" marks both ipv4 & ipv6 packets whereas "set ip precedence" only marks ipv4 packets.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.