Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

doubt switch config

Hi all,

I have seen some switch config and find some commands but I unable to understand faithfully coz. I am new.

Plz. experts can any body explain about these below config commands.

#priority-queue out

#mls qos vlan-based

#spanning-tree portfast

Thanks in advance,

Naidu.

4 REPLIES
Silver

Re: doubt switch config

Hello

priority-queue out: by default on some platforms the priority queue is not enabled, so if you want use for instance LLQ you have to use this command to enable the priority queue on the particular interface

mls qos vlan-based: enables per-VLAN QoS for a Layer 2 interface

spanning-tree portfast: put immediately the port to forwarding state by skipping the STP states (blocking, listening, learning, forwarding). Used on access port where _only_ host connected. Wise to use bpdu guard together.

Hope it helps, rate if does

Krisztian

New Member

Re: doubt switch config

Hi Krisztian,

Thanks for your early reply.

One more reservation that can u give some explanation about QoS and LLQ.

These are all actually using in VLAN concept only or any other.

Naidu.

Re: doubt switch config

Hi

Qos means as u know quality of service i.e providing better treatment for selected network traffic.

LLQ means low-latency queing which is the current queing method for dealy sensitive traffic.

Thanks

Mahmood

New Member

Re: doubt switch config

Hi

Thanks Mr. Mahmood and Krisztian for their good enlightenments.

Regards,

Naidu.

99
Views
8
Helpful
4
Replies