10-15-2013 07:25 AM - edited 03-07-2019 04:03 PM
I have trouble to install a Frame Relay service because the vendor sold me WIC cards but i think 2921 only supports HWIC cards
Here's the output of the show diag:
Router Llano Mall
ag321-acc-rou-01#sh diag | b WIC Slot 1:
WIC Slot 1:
Serial 2T (12in1)
WIC module not supported/disabled in this slot
Hardware revision 1.0 Board revision B0
Serial number 32098957 Part number 800-03181-02
FRU Part Number WIC-2T=
Test history 0x0 RMA number 00-00-00
Connector type PCI
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 12 01 00 01 E9 CA 8D 50 0C 6D 02 00 00 00 00
0x30: 58 00 00 00 04 04 08 00 FF FF FF FF FF FF FF FF
Router Cumaná
ag521-acc-rou-01#sh diag | b WIC Slot 0:
WIC Slot 0:
HWIC Serial 2T WAN daughter card
Hardware Revision : 2.0
Top Assy. Part Number : 800-34379-01
Board Revision : A0
Deviation Number : 115024
Fab Version : 02
PCB Serial Number : FOC15023T8C
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Fab Part Number : 28-8141-01
Product (FRU) Number : HWIC-2T
Version Identifier : V03
CLEI Code : COUIA1RCAB
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 05 89 41 02 00 C0 46 03 20 00 86 4B 01
0x10: 42 41 30 88 00 01 C1 50 02 02 C1 8B 46 4F 43 31
0x20: 35 30 32 33 54 38 43 03 00 81 00 00 00 00 04 00
0x30: 85 1C 1F CD 01 CB 87 48 57 49 43 2D 32 54 89 56
0x40: 30 33 20 D9 02 40 C1 C6 8A 43 4F 55 49 41 31 52
0x50: 43 41 42 FF FF FF FF FF FF FF FF FF FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Is there any command or any form that i can use this card to implement frame relay?
Thanks in advance
Alejandro
Solved! Go to Solution.
10-15-2013 08:43 AM
It looks like it's unsupported and a 2921 ISR G2 would accept an HWIC-2T instead.
http://www.cisco.com/en/US/products/ps10537/products_relevant_interfaces_and_modules.html#serialwan
Sent from Cisco Technical Support iPhone App
10-15-2013 08:43 AM
It looks like it's unsupported and a 2921 ISR G2 would accept an HWIC-2T instead.
http://www.cisco.com/en/US/products/ps10537/products_relevant_interfaces_and_modules.html#serialwan
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: