Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ds3 question

I have a full ds3 going into a 2800 series router. We then connect into a pix for the firewall.

I need to know if there is away to dedicate roughly 5 megs to one person/ip address.

1 REPLY
Gold

Re: ds3 question

If you apply something like the below on both ends of the ds3. You will need to reverse the access list so it matches correctly depending on if it is a source or a destination.

If you only need to reserve the traffic in a single direction you can not apply it to both sides.

Be aware if you are running a full rate ds3 (non ATM) card in a 2800 you may have issues running QoS and full line speed. Check your processor load after you attempt this to be sure.

class-map special-user

match access group name special-user

IP access extended special-user

permit ip host x.x.x.x any

Policy-map special-user

class special-user

bandwidth 5000

int sx.x.x

service-policy special-user output

91
Views
0
Helpful
1
Replies