Dual-Active Detection with Fast-Hello issue

[raut.pawan]

Hi ,

We have configured Dual-Active Detection with Fast-Hello  but still we are seeing dual-active recovery mode: No

Please suggest

6509#sh switch virtual dual-active summ
Pagp dual-active detection enabled: Yes
Fast-hello dual-active detection enabled: Yes

No interfaces excluded from shutdown in recovery mode

In dual-active recovery mode: No

6509#sh switch virtual dual-active fast-hello
Fast-hello dual-active detection enabled: Yes

Fast-hello dual-active interfaces:
Port       Local State    Peer Port    Remote State
---------------------------------------------------
Gi1/1/18   Link up        Gi2/1/18     Link up

[aukhadiev · Accepted solution]

Hi, 
it's not issue, so it should be actually, everything is OK...
You see - In dual-active recovery mode: No because your VSS system is running in normal mode/phase and there are No dual-active condition...

Once the detection technique identifies the dual-active condition, the recovery phase begins and you can see -  In dual-active recovery mode: Yes