Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Dual-Active Detection with Fast-Hello issue

Hi ,

 

We have configured Dual-Active Detection with Fast-Hello  but still we are seeing dual-active recovery mode: No

 

Please suggest

6509#sh switch virtual dual-active summ
Pagp dual-active detection enabled: Yes
Fast-hello dual-active detection enabled: Yes

No interfaces excluded from shutdown in recovery mode

In dual-active recovery mode: No

 

6509#sh switch virtual dual-active fast-hello
Fast-hello dual-active detection enabled: Yes

Fast-hello dual-active interfaces:
Port       Local State    Peer Port    Remote State
---------------------------------------------------
Gi1/1/18   Link up        Gi2/1/18     Link up

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Hi, it's not issue, so it

Hi, 
it's not issue, so it should be actually, everything is OK...
You see - In dual-active recovery mode: No because your VSS system is running in normal mode/phase and there are No dual-active condition...

Once the detection technique identifies the dual-active condition, the recovery phase begins and you can see -  In dual-active recovery mode: Yes

 

 

1 REPLY
Bronze

Hi, it's not issue, so it

Hi, 
it's not issue, so it should be actually, everything is OK...
You see - In dual-active recovery mode: No because your VSS system is running in normal mode/phase and there are No dual-active condition...

Once the detection technique identifies the dual-active condition, the recovery phase begins and you can see -  In dual-active recovery mode: Yes

 

 

180
Views
0
Helpful
1
Replies
CreatePlease to create content