I have an old Cisco 2600 router running IOS 12.4 with 4 ethernet ports available. The goal is to put this router in front of a firewall and have it split traffic between 2 ISPs based on access lists. For example all traffic on port 25 goes through ISP 1 and the rest of the traffic goes through ISP 2.
The firewall would only be configured with a single gateway.
What is the best way to go about this? I was thinking a NAT config, but not sure.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.