Dual MSFC , SRM standby keeps going into "Status other"
Dont know what would be causing this issue, currently have a 6506 switch with dual sups, switch configured as SRM , I upgraded the code on both the switch and the routers to be
exact versions, when it was firts install monsth ago the secondary sup and MFSCs were good in stanby. Noticed a week ago the stanby router in the "status other". I reseted module 2 to notice secondary sup and MSFC with a "Status standby" , checked the logs and all looked ok, show redundancy info were enabled after the module was rebooted. Now 6 days later the standby MSFC is back into "state other".
Would this be a bug of some type, I could not find one ? or is there any configuration tunning I should look into for SRM implementation. Attached logs
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...