Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

duplex mismatch

Hi All,

there are UC520 and IAD devices. in IAD, fa interface has "duplex full" and in UC520, fa interface has "duplex auto". when I do "show interface fa 0/0" in UC520, I see "duplex half" and I am receiving lots of collision errors.

any suggestion would be very appreciated.

Alex

3 REPLIES
Bronze

Re: duplex mismatch

Hello Alex,

Both       sides of a link should have auto-negotiation on, or both sides should have it       off.

http://www.cisco.com/en/US/tech/tk389/tk214/technologies_tech_note09186a0080094781.shtml#when

HTH,

Re: duplex mismatch

You have a duplex mismatch.

Here is a guide http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800a7af0.shtml

NIC - Auto.................Switchport - Auto     GOOD

NIC - 100/Full

Re: duplex mismatch

Sorry My other post was incomplete.

Here is the link  http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800a7af0.shtml

See table 1

Based on that you have a duplex mismatch.

Please rate all posts that help.

Mike

431
Views
0
Helpful
3
Replies
CreatePlease login to create content