Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Duplex set to Full with speed 10?

Hi,

Is it possible to set a port on a cat os to duplex full\speed 10 that is connected to a Ethernet interface on a router with duplex set to full. I'm experiencing latency connecting over my WAN. I want to replace the Ethernet with FE but in the mean time i'd like to set it up as duplex full. when i try to set port duplex full on the switch it says its in autosensing mode and stays at half.

Any idea?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Duplex set to Full with speed 10?

If the port is 10/100BaseT, yes you can configure it to 10BaseT/Full-duplex

SW1: (enable) set port speed 4/1 10

Port(s) 4/1 speed set to 10Mbps.

SW1: (enable) set port duplex 4/1 full

Port(s) 4/1 set to full-duplex.

SW1: (enable)

4/1 disabled 1 full 10 10/100BaseTX

1 REPLY

Re: Duplex set to Full with speed 10?

If the port is 10/100BaseT, yes you can configure it to 10BaseT/Full-duplex

SW1: (enable) set port speed 4/1 10

Port(s) 4/1 speed set to 10Mbps.

SW1: (enable) set port duplex 4/1 full

Port(s) 4/1 set to full-duplex.

SW1: (enable)

4/1 disabled 1 full 10 10/100BaseTX

804
Views
0
Helpful
1
Replies
CreatePlease to create content