%HSRP-4-DUPADDR : Duplicate address [IP_address] on [chars], sourced by [enet]
The IP address in an HSRP message that was received on the specified interface is the same as the IP address of the router. Another router might be configured with the same IP address. The most likely cause of this condition is a network loop or a misconfigured switch that is causing the router to see its own HSRP hello messages.
Check the configurations on all the HSRP routers to ensure that the interface IP addresses are unique. Make sure that no network loops exist. If port channels are configured, check that the switch is correctly configured for port channels. Enter the standby use-bia command so that the error message displays the interface MAC address of the sending router, which can be used to determine if the error message is caused by a misconfigured router or a network loop.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...