Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

dynamic desirable mode

Hello, on a 2960 switch, is the default switchport mode 'dynamic desirable' ?

How can I see what the swtichport mode is. When I do a 'show run' nothing regarding switchport modes is visible ?

Thanks for any help.

Everyone's tags (3)
3 REPLIES

Re: dynamic desirable mode

Hi,

Yes, it's the default switch port setting. Cisco device IOSs normally don't display the default setting/command in the show run.

Issue a 'show interface x/x switchport' command to verify on which mode it's in.

Sent from Cisco Technical Support iPhone App

New Member

Re: dynamic desirable mode

hi, you can use show int status  this is shows all interfaces status

Re: dynamic desirable mode

Hi Philip,

John is correct.

sh interfaces switchport brief

It will show an output like the below

Port        Status     Op.Mode  Op.Encap Channel-id Vlan

Te1/1       connected   trunk    802.1q   --          201,207

Te1/2       connected   trunk    802.1q   --          201,207

Te1/3       disabled    none     native   --          201 

Gi2/1       notconnect  none     native   --          201 

Gi2/2       notconnect  none     native   --          201

Gi2/3       connected   access   native   --          201

Please do rate if the given information helps.

By

Karthik

438
Views
0
Helpful
3
Replies