Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dynamic IP by Switch Port

Hello Cisco Team,

We have the following request from our production IT Team:

WE have certain production devices that are plug into our CISCO Switches such as PLC or Video Cameras. The question is it possible to assign these devices a dymamic IP based on the Port they plug into, the idear is that if a devices dies a production worker can switch out the devices. FOr the production it is curical that they obtain the same IP Address, therefore the question is it possible to setup dynamic/manual DHCP based on the MAC Address of the CISCO Port versus the MAC Address of the device?

 

Thanks
Christian

Everyone's tags (3)
4 REPLIES
Hall of Fame Super Gold

Not possible, as far as I'm

Not possible, as far as I'm aware.

Bronze

If the devices are in the

If the devices are in the same vlan, DHCP will do his job. If not check VLAN Management Policy Server (VMPS)

Purple

Hi,This is possible but I don

Hi,

This is possible but I don't know if it is implemented on all switch models.

you should take a look in Cisco feature navigator for this.I've just verified and it is available on 2960S-2960X-2960C and on 3560/3750.

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipaddr_dhcp/configuration/12-2sx/dhcp-12-2sx-book/dhcp-prt-bsd-aa.html

 

Regards

 

Alain

Don't forget to rate helpful posts.
New Member

Yes,You need to have a

Yes,

You need to have a LANBASE IOS software image. It is not supported on LANLITE IOS software image.

Regards,

XLG

 

58
Views
0
Helpful
4
Replies
CreatePlease login to create content