I am trying to understand Dynamic VLAN assignment using VMPS. The VMPS Client switch is a 2924XL with proper IOS. It is configured for VMPS as follows-
vmps server 192.168.3.2 ! Location of VMPS Server...confirmed reachability from Switch to the Server
vmps reconfirm 90
vmps retry 4
The VMPS Server is ready to accept the request.
The issue is as soon as I configure the switchport, the Switch puts all the switchports in Blocking state except the Trunk port. The Switch does not recognise the Host connected on the port when configured for Dyanmic VLAN assignment. If I configure the switch for static VLAN assignment, it works as desired. The topology is very simple and is attached here.
Once you have configured your ports as dynamic you have to disconnect the devices from the switch and connect them back. we were facing this problem too. The other option is that you execute a shutdown on all your access ports and then switch them back on (no shut) and then it should work.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...