Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E0 line up, protocol down

Need urgent help/suggestions - how can i get the E0 protocol up again

show ip int brief output

se0 line up, protocol up

e0 line up, protocol down

the e0 interface connect to a switch with a rj45 connection

1 REPLY
Hall of Fame Super Blue

Re: E0 line up, protocol down

Hi

Check

1) The cable and that is connected properly at both ends.

2) The switch port has been enabled and is not in shutdown mode.

3) The speed and duplex settings. Either set both ports to be auto/auto or hardcode the same settings on either end.

HTH

Jon

103
Views
0
Helpful
1
Replies