I am not sure about your exact req, but if you want to connect that inbetween two Modem (V.35 & G703) back-to-back then you need to use "Stright Cable". And if you want to connect from Modem (V.35 to Router Controller) you need to use the same cable.
Carl , is your terminology correct, g703 is normally using a coax cable so you just cross xmit to recv and vice versa, if it is e1 card that has utp connection then an e1 crossover cable will work as well as coax.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.