Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

E2500 router after at&t 2wire i38hg?

  I'm trying to install my Cisco e2500 after my att 2wire i38hg router (that is - the e2500 is hooked directly to a port on the 2wire) but I can't figure out how. I have tried several methods found online but none seem to work.

The issue is that the 2wire was installed in my son's room and is too weak to give a good signal through out the house so I wanted to run the e2500 in a central location and turn the wifi off on the 2wire.

Can someone please give me simple instructions on how to do this?

At this point the 2wire doesn't even see the e2500...

Thank you in advance for any help! No matter how little!!

Cheers                

392
Views
0
Helpful
0
Replies
CreatePlease to create content