Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ebgp Connection with PIM but no MP-BGP Configuration

Hi All,

Quick one if I may.

If you run eBGP with an external AS and you want to pass multicast over from one AS to another (lets say both ASs are within my admin control), can I just run PIM on the interfaces on both ends of the eBGP connection (lets say they are directly attached) and multicast will flow through?

Or do I have to configure MP-BGP?

Many thx indeed,

Ken

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: ebgp Connection with PIM but no MP-BGP Configuration

of course you can

MP-BGP not required at all

you need MP-BGP if you have MPLS network

by the way if you want to enable bgp between tow BGP domains in diffrent AS you may need to consider MSDP for better control and security

have a look at the following document:

https://supportforums.cisco.com/docs/DOC-8293

good lcuk

if helpful rate

Cisco Employee

Re: ebgp Connection with PIM but no MP-BGP Configuration

Hi,

If your AS is already aware of the Multicast source addresses, you can have MSDP between AS and have the traffic flow between AS. But incase, you dont have or dont need unicast traffic between sources in different AS, you need MP-BGP with multicast AFI and advertise the source prefix.

This will be only used for RPF and not for unicast traffic forwarding.

HTH,

Nagendra

3 REPLIES

Re: ebgp Connection with PIM but no MP-BGP Configuration

of course you can

MP-BGP not required at all

you need MP-BGP if you have MPLS network

by the way if you want to enable bgp between tow BGP domains in diffrent AS you may need to consider MSDP for better control and security

have a look at the following document:

https://supportforums.cisco.com/docs/DOC-8293

good lcuk

if helpful rate

Cisco Employee

Re: ebgp Connection with PIM but no MP-BGP Configuration

Hi,

If your AS is already aware of the Multicast source addresses, you can have MSDP between AS and have the traffic flow between AS. But incase, you dont have or dont need unicast traffic between sources in different AS, you need MP-BGP with multicast AFI and advertise the source prefix.

This will be only used for RPF and not for unicast traffic forwarding.

HTH,

Nagendra

New Member

Re: ebgp Connection with PIM but no MP-BGP Configuration

Many thx to all of you for the response.  This is great

Kind regards,

Ken

679
Views
0
Helpful
3
Replies
CriarFaça o para criar o conteúdo