Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Editing the excluded addresses in existing DHCP scope

Can someone please tell me how to edit the excluded address range in an existing DHCP scope? There's a present start and end range for addresses to exclude, I would like to edit that range. Please advise. Thank you.

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Editing the excluded addresses in existing DHCP scope

Hi,

it must be done before configuring the pool so you'll have to  do it all again from scratch because editing the excluded range won't have any effect on an existing pool.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
3 REPLIES
Purple

Editing the excluded addresses in existing DHCP scope

Hi,

it must be done before configuring the pool so you'll have to  do it all again from scratch because editing the excluded range won't have any effect on an existing pool.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
New Member

Editing the excluded addresses in existing DHCP scope

Thank you. So, I'm going to have to delete the pool and recreate it from scratch?

Purple

Editing the excluded addresses in existing DHCP scope

Hi,

yes you'll have to do that after editing the excluded list.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
929
Views
0
Helpful
3
Replies