HI, I was wondering if anyone has done this successfully, I'm trying to create a route-map for an EIGRP Distribute list on a N7K, the goal is to not advertise a 10.0.0.0/8 and 172.31.30.20/32 networks out a link to a remote site while permitting all other traffic to the internet (default). I configured the ACL/route-maps below and applied them outbound on the N7K interface but no subnets at all are being received on the remote site router, any help is appreciated.
ip access-list DENY_10.0.0.0
10 permit ip any 10.244.244.20/30 <<--WAN interface network
20 deny ip any 10.0.0.0/8
25 deny ip any 172.31.30.20/32
30 permit ip any any
route-map BLOCK_10.0.0.0 permit 10
match ip address DENY_10.0.0.0
ip distribute-list eigrp 1 route-map BLOCK_10.0.0.0 out
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...