I got alert for Router down.it was back up after 7mins.i check the logs they were clean.no circuit no Nei bounce.when i did sh ip eigrp nei it shows nei is uptime from last 5 mins.During alert i was unable to ping the router and its gateway.
Without any log messages, it's all going to just be a guess... :-( I would start by turning on eigrp log-neighbor-changes, and then you should get some notification of what is happening when a neighbor fails and comes back up.
Other than that, you can traipse through the EIGRP event log, and try to figure out which side actually went down, and possibly why, but that won't be an easy task, IMHO.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.