In my case, there are more than two routers on same vlan (one of that is MPLS router). We want to selectively make neighbor relation on eigrp and control selective route distribution - with routers on the same vlan. This is because i have few static routes those are redistributed into eigrp for using on internal network but do not want those on MPLS. With 'distribute-list' command i am not able ot selectively filter routes to selected routers.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...