Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

EIGRP not send to neighbors changes in delay values

Hi people.

I need your help. I have a problem when a try to change de route of EIGRP.

When i insert the command delay 300 (for example) in the subinterface, i can see the change where type the command "show interface g0/1.xxx", in the line DLY 3000 usec. But, in the neighbors, allways see "Total delay is 20 microseconds"

Which can the cause?

I remember that work!!.

The neighbors are connected beetwen then through Lan-to-Lan.

I expect your answer.

Greeting

1 REPLY

Have you check your K values

Have you check your K values?

Are you using redistribution at any point?

26
Views
0
Helpful
1
Replies