EIGRP offset-list changes metric despite no ACL configured
I have a question about EIGRP offset-list behavior on Catalyst 3750 12.2(44)SE. My customer informed me the following three cases and results.
Case 1 [Configuration] offset-list 0 out 100 Vlan10 [Result] Metric of all EIGRP routes outgoing through Vlan10 were added 100.
Case 2 [Configuration] offset-list 1 out 100 Vlan10 access-list 1 permit 192.168.10.0 [Result] Metric of the route matched access-list 1 (192.168.10.0) and if it is outgoing through Vlan10 was added 100.
Case 3 [Configuration] offset-list 1 out 100 Vlan10 [Result] Metric of all EIGRP routes outgoing through Vlan10 were added 100.
I think Case 1 and 2 are correct behavior but Case 3 is not. Because there is no any ACL in Case 3. I think no any EIGRP route's metric is changed, metric of all EIGRP routes outgoing through Vlan10 should be unchanged in Case 3.
In Case 3, customer did clear EIGRP neighbor and clear routing table but the symptom still occurred.
And customer tested Case 3 on another few IOS version, but same symptom still exit.
Do you have same experience? Do you have any information about this behavior.
I searched known bug on bug toolkit, but I couldn't find any.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.