Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EIGRP route filtering, use distribute-list, or ip sumary-address

I have a situation where I want to filter EIGRP routes being sent to a down stream switch (Layer 3). In this senario we have a 6513 sending routes to a down stream 3560E configured as a EIGRP stub-connected. My question is what is the preferred method to filter the EIGRP routes and only send a EIGRP default route to the downstream 3560E? Is it best to use a distribute list or the ip summary-address command? I know they pretty much do about the same thing. I have heard that a distribute-list is less risky since it does not place a default route to null0 in EIGRP topology route table.

Thanks

1 REPLY
New Member

Re: EIGRP route filtering, use distribute-list, or ip sumary-add

Will try summary address and then in distribute-list filter all except default using prefix-list

Filter Null entry out using distance if possible.

203
Views
0
Helpful
1
Replies