cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
325
Views
0
Helpful
2
Replies

EIGRP STUB in L3 Access switch.

jpolizzi
Level 1
Level 1

Access switch is running dual L3 uplinks to the distribution switch. All routes are being advertized to the access switch that only has 2 local networks. Is it best practice to apply an ACL at the distribution port to only allow the default route to the Access switch.

Looking for any info on EIGRP stub best practices..

2 Replies 2

Make the access L3 switch a EIGRP stub router. This way the distribution switch doesn't query the access switch for any networks that it wouldn't have been learning from another source.

Advertise only the default route from the distribution switch - you can do this by using either distribute list to allow default route only or use 'ip summary-address eigrp' command on the distribution switch.

HTH

Sundar

jpolizzi
Level 1
Level 1

Thanks!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco