Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

eigrp

Hi all, can someone tell me the different ways of advertising a default route in eigrp, i know the redistribute static, command, is there any other way of doing it ?

1 REPLY
bjw Silver
Silver

Re: eigrp

There are two ways to inject a default route into EIGRP: redistribute a static route or summarize to 0.0.0.0/0. Use the first method when you want to draw all traffic to unknown destinations to a default route at the core of the network. This method is effective for advertising connections to the Internet. For example:

ip route 0.0.0.0 0.0.0.0 x.x.x.x (next hop to the internet)

!

router eigrp 100

redistribute static

default-metric 10000 1 255 1 1500The static route that is redistributed into EIGRP does not have to be to network 0.0.0.0. If you use another network, you must use the ip default-network command to mark the network as a default network. Refer to Configuring a Gateway of Last Resort for further information.

Summarizing to a default route is effective only when you want to provide remote sites with a default route. Since summaries are configured per interface, you do not need to worry about using distribute-lists or other mechanisms to prevent the default route from being propagated toward the core of your network. Note that a summary to 0.0.0.0/0 overrides a default route learned from any other routing protocol. The only way to configure a default route on a router using this method is to configure a static route to 0.0.0.0/0. (Beginning in Cisco IOS Software 12.0(4)T, you can also configure an administrative distance on the end of the summary-address command, so the local summary does not override the 0.0.0.0/0 route).

router eigrp 100

network 10.0.0.0

!

interface serial 0

encapsulation frame-relay

no ip address

!

interface serial 0.1 point-to-point

ip address 10.1.1.1

frame-relay interface-dlci 10

ip summary-address eigrp 100 0.0.0.0 0.0.0.0

116
Views
0
Helpful
1
Replies
CreatePlease login to create content