We are building a VMWare based lab with a layer 3 IOS switch (3750) to do inter-vlan routing from the various vlans within the VM chassis. There will be no switch ports specifically assigned to the VLANS, only trunked interfaces into the VM Chassis. The VLANS are not coming up and subsequently we can't do inter-vlan routing via the L3 switch. Any way to fake out the switch?
Just to make sure you understand, its not the "name" command statement that made it come up, but the creation of the vlan itself in layer 2.
Without the command "vlan 10," for example, vlan 10 will not be created on the switch and will also not carry traffic across any trunk port, even if the trunk port is configured correctly. To the switch, the vlan doesnt even exist....
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...