enable and enable secret Password on 6506 doesn't word - Urgent help please
I put enable secret pass on one 6506 but it didn't allow me getting to the enbale mode using the same pass while I was console to it. on the second one i only put enable pass (same password) but same thing happend.
I lost the SUP on these machines (refurbished but under contract) and after I break inot them, I didn't configure Con 0 for login and line VTY 0 4 to login just to keep it simple during transition.
Now I cannot get to the both router's enable command prompt?
both has Cisco IOS (native).
Please help me with the steps to do that. I have done this hndres of times but given the timing and transition, it seems that I didn't do something right?
Re: enable and enable secret Password on 6506 doesn't word - Urg
Actually I think I know what the problem is here. There is no command "enable secret pass xyz" in CLI, the correct command is "enable secret xyz".
Let's presume that you wanted to have a password of "cisco"
If you typed in the commands:
R1(config)#enable pass cisco
R1(config)#enable secret pass cisco
then the first command will enable the password of "cisco", while the second one will enable the secret password "pass cisco". As the enable secret overrides the enable password command than in this case you will be able to use only the enable secret. (in your case "pass cisco").
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...