Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Enable store and forward on Cisco Switch

Hi all,

Got bad link and need to enable a switch for store and forward on all interfaces. I am using a Cat 2950 using IOS 12.1what do I need to do to get this working. I know the command syntex "switching-mode store-and-forward" every time I use the command I get %unrecognised.

2 REPLIES
Purple

Re: Enable store and forward on Cisco Switch

  As far as I know there is nothing you need to configure for this , that is what the switch uses

as its switching method and is not configurable .

Re: Enable store and forward on Cisco Switch

Hi all,

Got bad link and need to enable a switch for store and forward on all interfaces. I am using a Cat 2950 using IOS 12.1what do I need to do to get this working. I know the command syntex "switching-mode store-and-forward" every time I use the command I get %unrecognised.

All Catalyst switches use store and forward except the Nexus switches, as  switch  buffers and, typically, performs a checksum on each frame before forwarding it on to ports.

Hope to Help !!

Ganesh.H

Remember to rate the helpful post
1339
Views
1
Helpful
2
Replies
CreatePlease to create content