hi all,im trying to set up a lab im doing,ive got most of it configured but am having a problem entering the enc dot1q command,im using a 3620 router on ios c3620-i-m ver12.31(13a),i have the vlans all set up on the switches and can get into subinterface mode on the router but when i try to enter dot1q command it says unknown command and if i try to add an ip address it says i cant tilol ive entered the enc dot1q command.looking at the ? command there is no encapsulation command is this down to the ver ios i have???
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...