Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

encapsulation dot1q

I would like to configure encapsulation dot1q on a subinterface of a 2600 router with IOS version 12.2(11)T2. Unfortunately, I just found out that it is not supported. Can you please tell me what IOS version can support the said configuration with only 32K bytes of non-volatile configuration memory &

8192K bytes of processor board System flash (Read/Write)? Appreciate inputs. Thanks.

1 REPLY
Hall of Fame Super Blue

Re: encapsulation dot1q

Hi

It's probably not the IOS version but the feature set that you have a problem with. You need a minimum of IP Plus feature set to support 802.1q encapsulation.

If you are using a fast ethernet interface any version of IOS from 12.1(5)T IP Plus will do you.

If you are using one of the inbuilt ethernet interfaces you need any version of 12.2(2)T IP Plus onwards.

HTH

Jon

288
Views
0
Helpful
1
Replies
CreatePlease to create content