Is there a such command in Cisco Routers and Switches where you can get the details such as if the the current Device/IOS is End of Life and End of Support. I ran the tool "Auto Discovery" part of Netformx application, but it didn't provide such information, and am thinking that the device is currently supported and not end of life, but I like to check it manually through an IOS command.
The device itself does not track this information, but there is a module in CiscoWorks LAN Management Solution that ties into an online database which can provide this information. A 90-day eval of LMS is available at http://www.cisco.com/go/lms/ .
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...