Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

entering ip address in bit count format

Hi !

as we know, you can specify that the display of the  network mask appear in hexadecimal format or bit count format instead.  The hexadecimal format is commonly used on UNIX systems. The previous  example would be displayed as 131.108.11.55 0XFFFFFF00.

but I like to enter my address in this way

I mean instead of

int fa 0/0

ip address 192.168.1.1 255.255.255.0

i like to use 192.168.1.1 / 24

we have to enter many addresses in many interfaces and this would help me a lot  and also no need to convert /22 to ... hmm 255.255.252 and ..

thanks

Everyone's tags (5)
1 REPLY
Purple

entering ip address in bit count format

Hi,

As far as I know this is not supported as of yet at least on IOS platforms.

Regards.

Alain.

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
395
Views
0
Helpful
1
Replies
CreatePlease to create content