Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

EOBC0/0 - show ip route summary output

Guys,

Is the EOBC0/0 respsonible for the 1 "connected" network in the output of the "show ip route summary command" and this would appear on all 6500 routing architectures?, ie sup720s MSFC etc etc

6500>sh ip route conn

C 127.0.0.0/8 is directly connected, EOBC0/0

text omiited...........

text omiited...........

text omiited...........

6500>sh ip route summ

IP routing table name is Default-IP-Routing-Table(0)

Route Source Networks Subnets Overhead Memory (bytes)

connected 1 11 768 1824

static 0 36 2304 5472

Many thx indeed,

Ken

2 REPLIES
Silver

Re: EOBC0/0 - show ip route summary output

On Catalyst 5000 ATM modules, this will display as "1 Ethernet/IEEE 802.3 interface(s)" from show version and "Ethernet0" from show interface. On lower WS-X6101 IOS versions, this interface is displayed as EOBC0 (Ethernet Out of Band Channel) interface from the show interface command. Higher Cisco IOS versions, such as 12.1.13E, no longer display this EOBC0 from the show interface command. A show eobc command is available to display its status. This command is only introduced on Catalyst 6000.

ovt Bronze
Bronze

Re: EOBC0/0 - show ip route summary output

Usually you don't see this network, but it is always used to connect from SP to MSFC under CatOS:

SP# session 15

MSFC#who

Line User Host(s) Idle Location

* 1 vty 0 idle 00:00:00 127.0.0.51

2104
Views
0
Helpful
2
Replies