Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Equallogic and 6509

We are having major performance issues with our Equallogic. Equallogic is telling us that we need to buy a 3750 switch and connect the Equallogic to that instead of the 6509 switch. It is currently in a WS-X6148-GE-45AF and WS-X6148-GE-TX blade. It has 3 connections to the network of which it handles the load balancing. They tell us that due to Jumbo frames not being supported and some type of flow-control, that is the cause of all our problems. Does anyone have this configuration?

1 REPLY
Bronze

Re: Equallogic and 6509

The cat 6.5k has jumbo support. See http://www.cisco.com/warp/public/473/148.html

You might reply back with a sh ver and sh module so we can see any possible issues.

293
Views
0
Helpful
1
Replies
CreatePlease to create content