Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

err-disable state on etherchannel interface

Hi all,

We've configured etherchannel on 4 interfaces. 2 interfaces are up and 2 are down.

we have the following message when trying to enable the interface:

7w3d: %PM-SP-4-ERR_DISABLE: diagnostics error detected on Gi2/43, putting Gi2/43 in err-disable state

how can i solve this problem

5 REPLIES

Re: err-disable state on etherchannel interface

Hi,

This usually indicates a Spanning Tree issue. Not sure if you have a looped network or not (to make sure that its fault-redundand).

What are the devices connected to it? If its a server then, probably the server is Teamed ?

In any case, if you have a PortFast Enabled on the interfaces, I guess this shows up sometime (cant recall the exact cause in my case).

Could you please paste the switch config of the concerned ports please/

regards

New Member

Re: err-disable state on etherchannel interface

Hi,

on each 4 ports and each 2 switchs, we have the following config

interface GigabitEthernet2/XX

switchport

switchport trunk encapsulation dot1q

switchport trunk native vlan 600

switchport mode trunk

no ip address

channel-group 1 mode on

2 ports are UP, the 2 others are DOWN

Silver

Re: err-disable state on etherchannel interface

Try re-seating the module.

If you reload the switch you might see diagnostic failure on the ports.

I have RMAed some WS-X6148-GE-45AF and 6548 modules do to this.

New Member

Re: err-disable state on etherchannel interface

New Member

Re: err-disable state on etherchannel interface

Hi wilson,

We've seen so many causes of %PM-SP-4-ERR_DISABLE in your document.

However, we cannot find "%PM-SP-4-ERR_DISABLE: diagnostics error detected"

if you have some url or doc concerning this, would you like to post it?

652
Views
0
Helpful
5
Replies