Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

err-disabled

Hi

My port fa 0/2 of WS-C3560 is down :

FastEthernet0/2 is down, line protocol is down (err-disabled)

I'm using the cable crossover with furukawa switch.

It was functioning before( 1 year) but now it started to give this message. Why?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: err-disabled

Hi,

Looks like a speed/duplex mismatch. Try hardcoding the speed/duplex of both device port connected to each other. This happens to me even the switches has been running fine for years but in the background they keep negotiating the speed/duplex.

Dandy

5 REPLIES

Re: err-disabled

Hi,

Is there a port-security configuration in this switch?

Is there other error messages in the logs?

Dandy

Bronze

Re: err-disabled

check the interface "show int fa 0/2" and see what type of errors you are receiving (runts, crc, input errors, etc). Try swapping out the cable and also check to make sure that speed and duplex match on both switches.

New Member

Re: err-disabled

Hi.

No port-security.

See attach.

Bronze

Re: err-disabled

I see a large number of collision on the interface. Try setting the speed to 100 and duplex to full on the interface.

Re: err-disabled

Hi,

Looks like a speed/duplex mismatch. Try hardcoding the speed/duplex of both device port connected to each other. This happens to me even the switches has been running fine for years but in the background they keep negotiating the speed/duplex.

Dandy

307
Views
5
Helpful
5
Replies