Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Error booting Catalyst 2960 series need help

i need help somebody deleted boot image.  how can i restore it?

error1.PNG

error2.PNG

Everyone's tags (4)
5 REPLIES
New Member

Re: Error booting Catalyst 2960 series need help

If you have a console you can try and boot into ROMmon and xmodem an image to the switch. Be sure to change up the baud rate or you will be there all night. Google the above for a step by step guide..

Good Luck!

New Member

Re: Error booting Catalyst 2960 series need help

Thank you for the quick reply sweetfait. I tried you advice, please see attached images

The error said "No response from the remote system."

Purple

Error booting Catalyst 2960 series need help

First thing is  see if there is a image in flash. Do a dir flash:  and see  if there is any image at all in flash.  If not follow this doc for recovery.   

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

New Member

Re: Error booting Catalyst 2960 series need help

Thank you glen.grant for the reply.  I tried it step by step but the error said " No reply from the remote system".  Please see images above.

Bronze

Error booting Catalyst 2960 series need help

I think you missed a step...

You need to select from Hyperterminal window to Send a file to the switch usualy is Tools --> Send File.

Hope this helps

Eugen

3228
Views
0
Helpful
5
Replies
CreatePlease to create content