Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

error going to config mode on rma'ed msfc2

i am trying to get to config mode on the rmaed part but get error.

% Warning: Waiting for draco inventory message from SP.

% Reload MSFC without saving configuration if the MSFC does not recover.

% Configuration allowed only from Primary

also 16/1 show errdisable i am however able to session to it. can someone please help me with this.

4 REPLIES
Cisco Employee

Re: error going to config mode on rma'ed msfc2

Hi Friend,

Here is an explanation on the error message that you are seeing on the

switch.

% Warning: Waiting for draco inventory message from SP.

% Reload MSFC without saving configuration if the MSFC does not recover.

% Configuration allowed only from Primary

Explanation:

Upon Supervisor switchover, there is a message from the active supervisor

which tells who is the Master and who is the Slave. In this case, it is possible

that this message is lost or not sent by the supervisor.

The standby MSFC does not know whether it is the master or slave, so we can not make

configuration change and this is why we need to try reloading the session 16.

I would suggest you the following troubleshooting steps during a maintenance window.

1. Backup config from the sup and MSFC

2. Try to reload module 16

(enable) reset 16

3. If the module not comes up try to reseat the standby supervisor

4. If you still experience the same symptoms allow session 15 to come up as Master

(enable) set module disable 16

(enable) reset 15

Verify session 15 has come up in ok status on the output of "show module"

Bring up the module 16 if session 15 is in ok status

(enable) set module enable 16

Verify session 16 with "show module"

HTH

Ankur

*Pls rate all helpfull post

New Member

Re: error going to config mode on rma'ed msfc2

getting error

Cannot diable MSFC Module

Cisco Employee

Re: error going to config mode on rma'ed msfc2

Hi Friend,

Which module you are trying to disable? I believe you have Hybrid Mode running on your switch?

Also can you try reseating the standby sup again.

Regards,

Ankur

New Member

Re: error going to config mode on rma'ed msfc2

module 16. hybrid. i have reseating the standby same thing. i am not able to reset the active right now. will try when i have an open window to do so.

453
Views
0
Helpful
4
Replies
CreatePlease to create content