Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

error message in VSS

Hi,

I have 2 Catalyst 6500 working as VSS.

After making an upgrade of IOS (current: s72033-ipservicesk9_wan-mz.122-33.SXI.bin) gives the following error message:

SW1_SP: Insertion of mld_s_g_type in the tree failed WAVL grp

I searched information about this message but I have not found anything, someone who knows it?

4 REPLIES

Re: error message in VSS

If I am not mistaken this points to an internal software error. I would gather all the info and open a TAC case.

I will see if I can find some info on it.

Mike

Re: error message in VSS

You could also run show tech-support and see if anything shows up on that, you will need to run it for the TAC case anyway.

Mike

Community Member

Re: error message in VSS

this error is referred only to the supervisor in sw1 and it's not the same with supervisor in sw2...

it can be due to a bad insertion of the card?

Re: error message in VSS

It could be. I did some further checking and the WAVL does point to a software issue but I could not find the exact error anywhere. It could be some type of bug. We run VSS here but we are not running that IOS we use advipservicesk9_wan-vz.122-33.SXH3.bin

I would open a TAC case if you can or maybe reload the software as maybe it got corupt.

Mike

752
Views
0
Helpful
4
Replies
CreatePlease to create content