Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

error message when removing a provision swtich from a catalyst3750

this is a new switch and there is no other switches connected to it.

Two commands someho got in the configuration and I would like to take them out:

switch 1 provision ws-c3750g-24ts

switch 2 provision ws-c3750g-24ts

if I try to remove them, i get error:

ksfo510(config)#no switch 2 provision ws-c3750g-24ts

%IDBs can not be removed when switch is active

The show switch command shows that switch 2 is master so I suspect that I must make switch 1 master or somehow disable switch 2 logically.

ksfo510#show swit

Current

Switch# Role Mac Address Priority State

--------------------------------------------------------

1 Member 001c.0ea1.5880 1 Ready

*2 Master 001c.0ea1.4c80 1 Ready

any ideas how to remove these commands from the config?

1 REPLY

Re: error message when removing a provision swtich from a cataly

Why are you going to remove these commands from the config?

297
Views
0
Helpful
1
Replies