Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Error message

I received some error

%SYS-5-EOBC_CHANNELREINIT:Ethernet out of band channel reinitialized (1)

can't find any information. Please help.

  • LAN Switching and Routing
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Error message

Hi,

%SYS-5-EOBC_CHANNELREINIT:Ethernet out of band channel reinitialized (1)

Indicates that a non-fatal error has occurred. It will let you know when

the EOB

(Ethernet out of Band) TX queue of the internal ASIC was getting stuck.

When this condition

is detected, it reinitialize the ASIC without resetting the switch.

The message is an informational message meaning that the tx queue EOBC

was reset since the tx queue was filled up. The EOBC is a 100 meg half

duplex connection that the linecards use to communicate. Its normal if

occasionally this is reported as its just doing a self recovery. Various

traffic like reporting and NMS can cause this to happen. If its

continually happening in the 100s per day, then its possible that the

mistral asic might be malfunctioning, but if its not happening much,

then its nothing that will affect your switch operation.

HTH

3 REPLIES
Silver

Re: Error message

Hi,

%SYS-5-EOBC_CHANNELREINIT:Ethernet out of band channel reinitialized (1)

Indicates that a non-fatal error has occurred. It will let you know when

the EOB

(Ethernet out of Band) TX queue of the internal ASIC was getting stuck.

When this condition

is detected, it reinitialize the ASIC without resetting the switch.

The message is an informational message meaning that the tx queue EOBC

was reset since the tx queue was filled up. The EOBC is a 100 meg half

duplex connection that the linecards use to communicate. Its normal if

occasionally this is reported as its just doing a self recovery. Various

traffic like reporting and NMS can cause this to happen. If its

continually happening in the 100s per day, then its possible that the

mistral asic might be malfunctioning, but if its not happening much,

then its nothing that will affect your switch operation.

HTH

Cisco Employee

Re: Error message

New Member

Re: Error message

Thanks for the information, I see this message just two times in the syslog for last week. Will monitor this switch to see if it reappears.

220
Views
5
Helpful
3
Replies
This widget could not be displayed.