Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Error

HI all,

Error on initialize VLAN database 1: VTP feature not yet initialized[OK]

Anybody know what this error means.

Device running WS-C2950G-48-EI in Transparent VTP mode. Help me how can I solve this problem.

Thank You,

Ramesh

8 REPLIES

Re: Error

post the ouput of "show vlan"

New Member

Re: Error

Hi Andrew,

I have attached the output of show vlan herewith.

Thank You

Ramesh

Re: Error

Since your vlan database has over 30 vlans and there are no issues, I would ignore the error.

HTH>

New Member

Re: Error

I would too, but sometimes this switch is malfunctioning, even I could not log-in the switch. the buffer log shows :

*Sep 9 23:29:49.894 NST: %SYS-2-MALLOCFAIL: Memory allocation of 259644 bytes failed from 0x803B719C, alignment 0

Pool: Processor Free: 0 Cause: Not enough free memory

Alternate Pool: I/O Free: 136388 Cause: Not enough free memory

Re: Error

how long has it been up for? sometimes a reboot fixes all!

New Member

Re: Error

Hi Andrew,

First time when I found this problem, it has been up since Sep 9.

Exactily sometimes a reboot fixes all the problem and start works like a normal switch.

Ramesh

Hall of Fame Super Gold

Re: Error

Hi Ramesh,

I think your VLAN database is corrupt.

1. Delete the vlan.dat file

2. Enter the VLAN Database again.

3. Exit to save a new database.

See if this helps.

New Member

Re: Error

Hi Leo,

I will, but does this make permanent solution.

Ramesh

657
Views
0
Helpful
8
Replies
CreatePlease to create content