Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Errors in Cisco Router 2821

Hi,

In my router iam getting the following error

LINK-3-UPDOWN: Interface Virtual-Access2; changed state to down

I have done some investigations on this. but unable to resolved the issue.

some please help me on this.

CR1#debug vtemp

Aug 15 18:27:17.394: %DIALER-6-UNBIND: Interface Vi2 unbound from profile Di1

Aug 15 18:27:17.398: %LINK-3-UPDOWN: Interface Virtual-Access2, changed state to

down

Aug 15 18:27:18.378: %LINEPROTO-5-UPDOWN: Line protocol on Interface Virtual-Acc

ess2, changed state to down

CR1#

Aug 15 18:27:40.470: %DIALER-6-BIND: Interface Vi2 bound to profile Di1

Aug 15 18:27:40.474: %LINK-3-UPDOWN: Interface Virtual-Access2, changed state to

up

Aug 15 18:27:41.770: %LINEPROTO-5-UPDOWN: Line protocol on Interface Virtual-Acc

ess2, changed state to up

----------------------------------------------------------------------------------

interface Dialer1

description username=abc.net, password=abc,TEch suport=abc

-san

mtu 1482

ip address dhcp

ip verify unicast source reachable-via rx allow-default 100

no ip redirects

no ip unreachables

no ip proxy-arp

ip mtu 1472

encapsulation ppp

dialer pool 1

dialer-group 1

no cdp enable

ppp authentication chap pap callin

ppp chap hostname abc.net

ppp chap password 7 xxxxx

ppp pap sent-username abc.net password 7 xxxxxxxxx

--------------------------------------------------------------------------------------

CR1#show interfaces virtual-access 2 conf

Virtual-Access2 is a PPP over Ethernet link (sub)interface

Derived configuration : 277 bytes

!

interface Virtual-Access2

mtu 1482

no ip address

ip mtu 1472

pulse-time 0

ppp authentication chap pap callin

ppp chap hostname abc.net

ppp chap password 7 xxxxx

ppp pap sent-username abc.net password 7 xxxxxxxxx

end

OSAOCVCR1#

-----------------------------------------------------------------------------------------

284
Views
0
Helpful
0
Replies
CreatePlease to create content