Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Errors with module1

Hi people,

I am getting the status from module1 is MinFail & for module2 is ok.

I think the Chasish crossed the minimum temperature am i right?

Message: module 1 inlet temperature crossed threshold #1=45C

Switch>sh module 1

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

1 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL1103E6A3

Mod MAC addresses Hw Fw Sw Status

--- ---------------------------------- ------ ------------ ------------ -------

1 001a.a1a2.e610 to 001a.a1a2.e63f 1.5 8.4(1) 8.5(0.46)RFW MinFail

Mod Online Diag Status

---- -------------------

1 Pass

Switch>sh module 2

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

2 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL1151AN2J

Mod MAC addresses Hw Fw Sw Status

--- ---------------------------------- ------ ------------ ------------ -------

2 001e.7af9.16b0 to 001e.7af9.16df 1.6 8.4(1) 8.5(0.46)RFW Ok

Mod Online Diag Status

---- -------------------

2 Pass

Experts can anybody plz. suggest me on this.

Regards,

Naidu.

2 REPLIES
Hall of Fame Super Silver

Re: Errors with module1

Hello Naidu,

have someone check the cooling system for the rack.

Just to see if something changes you can open the rack door if any.

best regards

Giuseppe

New Member

Re: Errors with module1

Hi Giuseppe,

Thanx for your reply.

I am at remote location so i need to check with them.

Regards,

Naidu.

285
Views
0
Helpful
2
Replies