Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Establish communications between data center using single connections to each layer 2 device

Were in the process of developing a network between two data center using Cisco Nexus 5k with the overall concept of having an active-active process during normal business hours. Thus far, I have been able to communicate between sites using a 1:1 ratio Nexus1 can communicate with Nexus1 using the same fiber circuit however I'm unable to communicate from Nexus1 to Nexus 2. I have attempt to use port channeling with unique names placing all the required vlan on this channel group however I was unable to see that device as a neighbor. Any suggestions?

thanks

268
Views
0
Helpful
0
Replies
CreatePlease to create content