Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ESX Trunk ports CATOS

I used the following command to setup trunk ports to my ESX Server both Broadcom and INtel NICS

set trunk 1/14 nonegotiate dot1q

set spantree portfast 1/14 enable

But when I run

sh trunk

I see that other ports are using "on" instead of "nonegotiate" and also the other trunk ports have native vlan at 1. and this trunk port I configured at native vlan 50. Any idea why?

1 REPLY

Re: ESX Trunk ports CATOS

Hi,

if I remember correctly from the CatOS times, the other ports are having

set trunk x/y on dot1q

configured probably.

Regarding your second question:

The native VLAN is configured by

set VLAN z  x/y

command in CatOS.

HTH,

Milan

328
Views
0
Helpful
1
Replies